Where is the coolant temperature sensor???

Hey everybody--I think I have a bad coolant temp sensor--the radiator fan is on all the time and the temp gauge stays on cold all the time. The heat is hot, though. Plus the check engine light is on.
Anyway, I can't find the coolant temp sensor. I have a '97 cav. Does anyone know where it is located on the engine? The coolant system is kind of nontraditional.
Thanks.

http://www.autozone.com/images/cds/jpg/small/0900823d80191d79.jpg (javascript:pop()
Fig. 1: The ECT sensor is located in the water outlet housing, adjacent to where the upper radiator hose connects to the engine
http://www.autozone.com/images/cds/jpg/small/0900823d80191d7a.jpg (javascript:pop()
Fig. 2: ECT sensor location-2.4L engine

http://www.autozone.com/images/cds/jpg/small/0900823d80191d7b.jpg (javascript:pop()
Fig. 3: ECT sensor location-1998-00 2.2L engine

The Engine Coolant Temperature (ECT) sensor resistance changes in response to engine coolant temperature. The sensor resistance decreases as the coolant temperature increases, and increases as the coolant temperature decreases. This provides a reference signal to the PCM, which indicates engine coolant temperature. The signal sent to the PCM by the ECT sensor helps the PCM to determine spark advance, EGR flow rate, air/fuel ratio, and engine temperature. The ECT also is used for temperature gauge operation by sending it's signal to the instrument cluster.
The ECT is a two wire sensor, a 5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature.

TESTING
See Figures 4, 5 and 6
http://www.autozone.com/images/cds/jpg/small/0900823d80191d7c.jpg (javascript:pop()
Fig. 4: Detach the connector on the ECT sensor

http://www.autozone.com/images/cds/jpg/small/0900823d80191d7d.jpg (javascript:pop()
Fig. 5: Measure the resistance across the ECT terminals on the sensor

http://www.autozone.com/images/cds/jpg/small/0900823d800e5643.jpg (javascript:pop()
Fig. 6: ECT sensor resistance value chart


Disconnect the engine wiring harness from the ECT sensor.
Connect an ohmmeter between the ECT sensor terminals.
With the engine cold and the ignition switch in the OFF position, measure and note the ECT sensor resistance.
Connect the engine wiring harness to the sensor.
Start the engine and allow the engine to reach normal operating temperature.
Once the engine has reached normal operating temperature, turn the engine OFF.
Once again, disconnect the engine wiring harness from the ECT sensor.
Measure and note the ECT sensor resistance with the engine hot.
Compare the cold and hot ECT sensor resistance measurements with the accompanying chart.
If readings do not approximate those in the chart, the sensor may be faulty

Wow! Thanks for the info--I really appreciate it. I will test it first according to those directions to make sure that it is bad.

Wow! Thanks for the info--I really appreciate it. I will test it first according to those directions to make sure that it is bad.yeah no problem man. just trying to help ya out. and good luck with it. :bigthumb:

man wtf do you have a ton of engine pics on your computer lol

man wtf do you have a ton of engine pics on your computer lolhahaha no I just have my sources lol

what a hacked version of the haynes book. There is some program called (something)all can't remember what the first word is. Need to get a version of that

what a hacked version of the haynes book. There is some program called (something)all can't remember what the first word is. Need to get a version of thatno i dont use haynes. never even picked that book up.