99 Taurus 1451 code

Just got a 1451 code (of course after I cleaned the motor). Any suggestions? Thank you

Looked it up for you,, canister vent solenoid issue.. either there's a circuit issue which could be, maybe a connection got wet when you cleaned the motor, maybe something became unhooked,,, the pcm has failed, resistance, ground problem... I'd fool around with the connections first since this happened after the cleaning, take it from there.

You didn't use a pressure washer or steam cleaner to clean the engine, did you? If so, the number 1 culprit is moisture in a connector with "unplugged connector or hose" in a close 2nd.

-Rod

not a pressure washer but I did use a hose. I'll do a little more digging and see if it comes up again. Thank you

I had reset the CEL and it came back on again. The vehicle seems to run fine but can you give me an idea where I should start looking on this to check connections? I apologize but I am not real familiar with the Taurus like I am with the Crown Vic. Thank you

Hello Kev. Glad to see ya over here also. It is located under the back of car under spare tire well

http://usera.imagecave.com/way2old/taurusCV.gif

you certainly are the man. Thank you W2O