altima hesitating ALOT
InnerDragon103
06-15-2006, 02:39 AM
once again, we have a problem.
94 altima gxe 5spd. My altima is hesitating ALOT when i accelerate hard -- its almost hazardous to try to pass someone when i dont have alot of time... I suspect the clutch is of course worn (127000mi) but not useless.
When i start from a dead stop, the rpm needle makes an inconsistent climb to whatever RPM until it hits around 3000, then its pretty constant, this occurs most in the first and second gears. its not really noticeable in the other gears.
If i try to floor it from a dead stop, you can hear from the low pitch of the exhaust that the throttle's all the way open, but the car crawls until it finally starts really revving up.
Is this a transmission problem? Could be the clutch? I replaced the fuel filter very recently so i dont suspect clogged lines.. anyone have any ideas?
94 altima gxe 5spd. My altima is hesitating ALOT when i accelerate hard -- its almost hazardous to try to pass someone when i dont have alot of time... I suspect the clutch is of course worn (127000mi) but not useless.
When i start from a dead stop, the rpm needle makes an inconsistent climb to whatever RPM until it hits around 3000, then its pretty constant, this occurs most in the first and second gears. its not really noticeable in the other gears.
If i try to floor it from a dead stop, you can hear from the low pitch of the exhaust that the throttle's all the way open, but the car crawls until it finally starts really revving up.
Is this a transmission problem? Could be the clutch? I replaced the fuel filter very recently so i dont suspect clogged lines.. anyone have any ideas?
InnerDragon103
06-15-2006, 04:52 PM
ah yes, in addition "blipping" my throttle apparently is not possible; what i mean to say is that the throttle really isnt responsive like that at all, i have to give it a really good amount of gas to raise up rpms if im in the lower range, know what i mean?
FixUrNissan
06-17-2006, 11:40 PM
Sounds like a clutch to me, Those are the sighs . GL :)
InnerDragon103
06-18-2006, 11:23 AM
A clutch job huh? how much in labor am i gonna have to dish out? apparently its easy enough to buy the clutch kit and flywheel myself, about 250 i'm estimating; anyone know of what a decent estimate is for labor???
Automotive Network, Inc., Copyright ©2026
