Fuel Cell

Does anyone know where I might be able to find something like what is in this picture, the one to the left with the two inlets for the fuel. The model I'm working on is 1/25th scale

http://www.fuelsafe.com/parts.htm

I wanted to post just the picture, but couldn't. sorry all.

Thanks for your time...

Trevor

Hi

I think you can do it scratchbuilding.

Miguel

it shouldn't be too hard to scratchbuild. Get some thin styrene sheet. and some apropriate sized aluminum tubing and a mini mitre box would help. Cut the pipe at about a 45 degree angle. then cut them to the proper length with a square cut on each end. they will then both have the same degree angle with respect to the cell and be symmetric. Position them, then hit them with some CA on the inside to hold them in place. to get that welded look, take some thick CA and run a bead around the bottome of each tube

OK. I hada feeling schratchbuilding was going to be the way, but wanted to ask on here.

Thanks.