92 ranger fuel gauge

I have a 92 Ford Ranger 3.0L and i recently replaced the cold start valve and got a CB antenna and hooked it up. But the problem is i Filled my tank on sunday and then monday i mounted and wired my CB. Then a few days after that i noticed that the fuel gauge quit working and it always stays on E. And i looked around and they said the sensor in the tank. But i was wandering if there are any wires under the dash i could have bumped. Ohh and all the other instruments in the panel work it is just the Fuel Gauge!!
Thanks for the Help
Alex

did you by chance blow a fuse while wiring up CB? or try changing the power source for CB.

I checked all the fuses and they are all good and i did rewire the CB. so its not even near the lines up around the fuel gauge. I have a question also, can the sensor in the tank just go out like that and quit working??
Thanks

ya. you could have shorted it out trying to hook up CB. thats all i can think of. they can just stop working but in your case i think it was related to what you were doing.

Ok thanks so all i can do is replace the sensor?!? thanks again for the help
Alex