manual swap soon

Well, i finally did it. Found a T3650 on ebay with my name on it. 8,800 miles from an 02, "pickup only" from Georgia, so naturally nobody wanted it. On the AL/Ga line about 100 miles from my house. No one bid and i got it for $350. Very happy. I'll go Friday or Saturday to pick it up.

I hope to find a good deal on a spec clutch (St2 i hope) and a Tri-ax.

Any help whatsoever would be appreciated on the parts needed or installation suggestions.

I know i need these:
clutch and plate
clutch cable
pedal assembly
Shifter
flywheel

I am confused on the driveshaft, crossmember, and neutral safety switch though. Any left out? Please let me know what all i need and what is the same.

http://www.3.8mustang.com/forum/showthread.php?t=56623 Its for V6's but a lot of the stuff is the same.

thanks for the site, but i need to know for sure.

Do i need to buy a driveshaft or crossmember?

I am pretty set on a spec clutch; is there any reason to buy a stage 2 over a 1, if i intend on keeping it mostly stock? Is it better for launching or anything?