Our Community is over 1 Million Strong. Join Us.

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD

94 starts and dies


canonoch
03-18-2006, 12:53 AM
Hi all,

Got a 94 Lesabre, Wife went to work, went to leave, started car, and car dies.

It seems like it will start no prob and run while cranking when key goes to run position it dies. Sets no codes

Tech has replaced crank sensor, ICM, Pass Module, ECM. Still no luck.

Any Ideas, Suggestion, or solutions

All answers Appreciated
HotZ28
03-18-2006, 06:24 AM
A faulty VATS module could cause the car to stall once the engine is running. The module sends a Pulse Width Modulated signal to the PCM. If this signal is not present, the PCM will not provide injector pulses thus causing the engine to stall. Have your injectors tested with a noid light while stalled, or not starting.
davey 58
03-18-2006, 12:43 PM
had same problem on 95 it was bcm tried used one still running $60.00
dmblover4136
03-31-2006, 05:20 PM
I had the same problem and it was the air filter hose had a small cut in it. This might work might not

Add your comment to this topic!