Our Community is over 1 Million Strong. Join Us.

Carnivore Diet for Dogs

AIR DRIED BEEF DOG FOOD

oK HELP AGAIN


ecg2647
03-13-2006, 05:36 PM
i changed the #6-3 coil pack, EGR valve,Mass air flow sensor,wires,plugs,fuel filter,neg cable,o2sensor,ok if i run car for about 1-1/2 still shutit off and try to start it after about 20mins it will start but still putter and stumble idle is a little rough. Ok could this be the TPS or the IAC? its a 94 Bonnie not super charged The reason i changed the MAF sensor I was always told if you unplug it and car stays running its bad. So after 300.00 for the EGR valve MAf sensor and other stuff and a huge headache Im gonna sell it for a penny. I need this car as no money to get a new one and cant afford to have car in garage I do all work myself. in previous post I stated car was coded and had these codes
1-EGR pintel postion sensor
2-Tourque (not sure forgt)
3-Cruise control
had a few stored but cleared them and they are gone so far.
well any help would be greatly accepted and I do appriciate it greatly.
Thanks
Michele

3.1L 200+hp
03-14-2006, 09:53 AM
what about the fuel pump relay?

jdq
03-16-2006, 12:59 AM
Possible crank sensor or torque converter clutch.Go to Bonneville club.com and search these.Or ask youll figure it out.

Add your comment to this topic!