Help Wid This Dumb Noise Prob!!!!!!
Team PHATBOYZ
03-03-2006, 06:42 PM
Hey guys! OK heres the deal. Well i just got a new transmission and installed and only drove it to work and back and then this wierd sound just started. Like a loud GRINDin sound. The car can't even move anymore? It would go in gears but the sound would get louder. so basically u can't DRIvE THE CAR then i guess. lolz. But yea! So when i start up my car, i have to step and hold on to the clutch pedal to make the grindin sound stop. If i let go then somethin grinds? Is it my Tranny? or is it somethin else? N E 1 knos HOLLATCHABOY! (note: b18a swap)
clawhammer
03-03-2006, 08:54 PM
Is there transmission fluid in the tranny?
FrodoGT
03-03-2006, 09:08 PM
My transmission makes a little bit of noise all the time, but I'm sure its normal, just barely audible if you put your ear like right on it, its the internals always spinning...I would say your a little under lubricated..Or youve got a messed up bearing, thats just scraping itself round and round...
FuLL BLown STD
03-03-2006, 10:33 PM
sounds like both of u guys got bad throw out bearings.. my throwout was making the grinding sound to but i never had my car lockout on me.
FrodoGT
03-03-2006, 11:06 PM
Thats what I meant when I said bearing...But mines not grinding, just sounds like bearings turning....just sound.
Team PHATBOYZ
03-04-2006, 09:14 PM
HAHAH thx guys butta i found out the prob. It was my freakin ACT clutch plate that was worned out. Like the middle where the tranny gear goes into. Yea the ACT clutch plate was all freakin worned out. So yea.. Wait do u guys think its the tranny that caused it?
FrodoGT
03-05-2006, 12:22 AM
Hmmm, I have an ACT clutch *sneakes out the door with various wrenches and a hammer*....
Hybrid1990crx
03-05-2006, 01:32 PM
sounds like both of u guys got bad throw out bearings.. my throwout was making the grinding sound to but i never had my car lockout on me.
is that right? so you think that when the clutch pressed the floor to make the noise stop that its the throw out bearing? Isn't that when the bearing is spinning, Dustin? So technically if it was the throwout bearing the noise should stop with the clutch pedal up and make the noise with the pedal pressed. Unless its a fulltime throwout bearing, which cable honda trannys arent. :rofl: :rofl: :rofl: :rofl: :rofl: :rofl:
is that right? so you think that when the clutch pressed the floor to make the noise stop that its the throw out bearing? Isn't that when the bearing is spinning, Dustin? So technically if it was the throwout bearing the noise should stop with the clutch pedal up and make the noise with the pedal pressed. Unless its a fulltime throwout bearing, which cable honda trannys arent. :rofl: :rofl: :rofl: :rofl: :rofl: :rofl:
FrodoGT
03-05-2006, 05:44 PM
Smacked down! Eh everyones wrong sometimes... Couldn't hurt to check everything though...Hope for the best, plan for the worst.
FuLL BLown STD
03-05-2006, 05:54 PM
Lick my balls Brian:icon16: yeah im never bothered when i stand corrected:banghead:
Hybrid1990crx
03-06-2006, 06:30 AM
don't worry dustin i still love your fat ass.
Automotive Network, Inc., Copyright ©2026