some questions

ok, so i have two questions, are the header gaskets for my 305 round or squar? And will this tranny mount bolt right up to my car? http://www.jegs.com/webapp/wcs/stores/servlet/CategoryDisplay?catalogId=10002&storeId=10001&categoryId=13001&parentCategoryId=10729&langId=-1

Square and yes....anything else

cool, i think that is it. So i don't have to mod any thing? it will bolt right up?

what headers did you get....with my headers all i had to do was make the oil dipstick tube fit...and that was a bitch

i was talking abotu will the tranny mount bolt right up? But here is the headers i got, not bad for only $120. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8040442331&sspagename=STRK%3AMEWN%3AIT

and when i put the headers on, do i have to torque them down to a certen number? and what should i do with the air lines? should i just clamp them shut?

yes that poly mount will work...and for the headers i was told to tighten the headers with my hands as tight as i can then run the car for a few minutes let it cool down and go over them again....then in about another month go check them again and tighten them down again if needed...then i was told i needed to check about every 6 or so months to see if they are backing out any...i heard about these header bolts that have this kinda c-clip on it so it doesnt back out but i havnt been able to find them...i think im just going to use a litte locktite