VAFC 2 Intial Setup

So I just put this in my car did l the wiring and installed it myself. It was really easy to do even with a hangover.....In the manual it has intial settings to be programmed in before using I dont know what to put in...Ex. Sensor numbers in and out. Throttle sensor ?? Display scale setting mode with PR: NE: CR:. My car runs fine for with what I set up already have in there. My throttle in the monitor mode wont show either its either on 0 or when i change the throttle sensor its at 99%?????? If somebody has this or the previous one and knows what is the proper settings please help me out...I have a 93 Del Sol Si D16Z6

Next week my turbo goes on how much HP you think I can pump out with stock internals?

http://www.beesandgoats.com/boostfaq/g2icturbo.html

as far as your initial settings go, i believe its on page 12-13 in the manual.

if you dont have the manual.............well, here you go.

http://www.apexi.com/

I have the manual it doesn't say shit just how to change the numeric value..

concerning the fuel and throttle position settings go, leave it alone and wait for the dyno, you must of known that before getting the vafc ;) what you really need to reset is the vtec crossover. the initial setting on the vafc should be different. as for setting using someone elses settings, no one car is alike (so remember that).

things that need to be set are things like a map or maf, # of cylinders, etc.

dont rely on me on this. its been 7+ years since ive touched anything vafc or even hack related. you can also try homemadeturbos.com and http://www.turbod16.com/. there are many members there that still hack.

I ll go ahead and intialize it but what about the # of sensors ?? and all the other setup shit??? I have the tuner do that shit I hope hes good. I go next week for my turbo so it should be all good ill post the slips on here if it works