Our Community is 940,000 Strong. Join Us.


Installing Subwoofers


VR43000GT
01-09-2006, 02:08 PM
I am installing new subs in my 3kgt and I cant find a place to run my positive power wire from my battery to my amp. There is almost nowhere to drill a hole in the fire wall either. If any of you have had the pleasure of doing this please let me know how or show me where I can find pictures of this being done. Thanks.

Steermaster
01-09-2006, 03:19 PM
Somewhere on the fire wall is a hole already cut that has wires running from teh engine to the dash and all that. Locate those wires and run your wire through where they are. Normally on passenger side but it coudl be different depending on your model. It helps to use black tape and use a clothes hanger that is taped 7-10 inches up on the wire and used to put it through. To locate the wires sometimes its easier to look on the firewall under the hood. Let me know how it all works out!!
NFL2009@aol.com if you have nay mroe questions that need quick response jsut IM me

Gateway
01-09-2006, 08:08 PM
i've heard of people finding a hole on the passenger side firewall, but i assume they have 2nd gens. I have a first gen and what I did was underneath the driver side there is a hole to a firewall where the steering colum goes into the engine bay. There is a big rubber piece around that, what i did was run my wire through that rubber.

Stealthy-One
01-09-2006, 09:08 PM
here. this applies to all stealth 3000gt's.

http://i8.photobucket.com/albums/a21/schollianmj/dashpanelaccess.jpg

I hae a 0 gauge wire going behind the Batt, to my distro block in the spare tire well.

thunderchicken2
01-12-2006, 12:33 PM
I don't know about the 3kgt, but in my 1st gen Stealth, there is a rubber grommet already in place in the drivers side, directly behind the clutch pedal and above it. They already had it cut and wires running through, so I had no problem with it. What type of system are you putting in?

Bansheewild88
01-12-2006, 02:11 PM
There is a hole with wires coming through the fire wall right behind the radio area. if you take apart the side of ur middle consul u shoudl beable to see it. it runs right through to the other side. just cut a place for the new wires through the plastic part and u shoudl be good thats wut i did.

Stealthee
01-12-2006, 09:08 PM
No need to take apart the console. As stated there is a grommet kinda below the battery box area, and another over by the pedals. Mine is coming in by the pedals, and run under my console, under the carpet and under the back seats. Wires are 100% hidden other than by the amp itself.

Add your comment to this topic!