Temperature Gauge Problem 92 S-10 Blazer

Whe I start the vehicle COLD the temperature gauge alway going right to MAX every time I start it!! If I shut it off and start it the next day it still does the same thing...

Any suggestions?? We have recently replaced the Coolent Senor in it but this still bothers....

Any suggestions appreciated. Also i do not own a scan tool either.

But it not giving any codes either when you short A snd B in the diagnostic terminal.

It sound like the sending unit circuit has an open(diconnected?) The sensor and the sender are different. the sensor(usually 2 wire) is for the ecm(codes etc.) the sender (usually 1 [green] wire) is for your guage

Well that sounds like a good reason, as the vehicle dont act any different with that being on MAX. So got to be the computer is reading the temp ok. As I hear the Coolant Temperature Sensor plays a MAJOR part in how the vehicle runs!!

But it does make the Check gauges light stay on, now is that operated off the computer or directly off the temp guage???

I dont know if its part of the "ECM" but something is prbly monitering your guages for you. Alot of people dont watch thier guages so this is a system to help ensure engine life lol.

Ok i will try your options and get back to you when I get a chance to check this out about that (green) wire!!

Thanks for the info however!!

Did you replace the Coolant Temp Sensor? I just had problems with mine acting crazy ( Needle jumped all over the place) Replaced the sensor ( drivers side of car) and all is well again.


Whe I start the vehicle COLD the temperature gauge alway going right to MAX every time I start it!! If I shut it off and start it the next day it still does the same thing...

Any suggestions?? We have recently replaced the Coolent Senor in it but this still bothers....

Any suggestions appreciated. Also i do not own a scan tool either.

But it not giving any codes either when you short A snd B in the diagnostic terminal.

Did you replace the Coolant Temp Sensor? I just had problems with mine acting crazy ( Needle jumped all over the place) Replaced the sensor ( drivers side of car) and all is well again.

Well I did replace the sensor before and it corrected it for a little while, but it then started acting up again. plus now it stays on MAX all the time and I cannot get it to go off the MAX Mark...

Did you take a close look at the connector? mine was really dirty and Oxidized. Take a look with a bright flashlight, maybe it could be doing it.

Well I did replace the sensor before and it corrected it for a little while, but it then started acting up again. plus now it stays on MAX all the time and I cannot get it to go off the MAX Mark...