getting ready to put a b16a into my crx si, wut other parts will i need

hi, im mostly doing research on putting a b16 into my 91 crx, i no i need motor mounts, can u tell me everythign else i need to put in it to make it run, thanks

did you try and search?

new axles, shift linkage, ECU.....

the b16a sir 1 swap is the most common and easiest crx b series swap and has the most info out there on the internet covering it.

assuming this is a drop in an si chassis. parts needed are:
b16a sir 1 engine of course.
cable tranny (Y1, J1, S1, or YS1)
PR3 or PW0 ecu (PR3 recommended.)
mount kit
harness conversion (or wire it yourself)
axles (90-93 teg)
radiator hoses (92 gsr and 90 gsr)
throttle cable (90-93 teg)
90-93 teg rear bracket and two side mount bolts
linkage (cut your own or get it from hasport)

you should also note, that, the engine you get is most likely more than 14-15 years old. if your like me when i did my b16a swap in my old rex, its a good idea to swap out the timing belt, water pump, clutch, oil filter, valve cover gasket, and spark plug O rings. it will save you some headaches down the road.

PS:

if the b16 goes in an HF, you will need 90-93 teg steering knuckles and hub.

in a dx, you need to convert to mpfi.

sounds like you've done it a time or two...

thanks alot, that helped me out alot, one more thing, which is the best website to buy a motor, which is most realiable

www.hmotorsonline.com

thanks alot, that helped me out alot, one more thing, which is the best website to buy a motor, which is most realiable

http://www.osakajdmmotors.com/introhonda.htm