Rebuilding my d16a6, what am I missing?

Well, i pulled my d16a6 and put in the almighty putt putt DX(d15b2) engine in my car....I am wanting to completely rebuild my Si motor to 0 miles. Here is a list of what i am going to buy/bought so far..

-89 integra p29 pistons- bought
-89 integra piston rings- bought
-rod bearings
-rear main seal
-head gasket
-valve cover gasket
-timing belt
-shotpeened rods
-lighteded/shaved flywheel
-new clutch
-valve job/cleaning
-port/polish
-valve stem seals
-intake gasket
-exhaust gasket
-oil pan gasket
-spark plugs
-spark plug wires
-cap
-rotor

Wel this is my list so far...what am i MISSING?
I have never rebuilt an engine so i need from some of you motor heads. :) Thanks in advance.

Originally posted by RedRacerCivic

-89 integra p29 pistons- bought
-89 integra piston rings- bought
-rod bearings
-rear main seal
-head gasket
-valve cover gasket
-timing belt
-shotpeened rods
-lighteded/shaved flywheel
-new clutch
-valve job/cleaning
-port/polish
-valve stem seals
-intake gasket
-exhaust gasket
-oil pan gasket
-spark plugs
-spark plug wires
-cap
-rotor


in addition: you will need a ton of more parts.

head bolts, entire valvetrain(springs rockers etc), water pump, cam shaft, pulley, throttle body, all gauges and sensors, radiator, etc, etc.

for a full rebuild you will need everything. pick up a helms manual and just follow there engine tear-down section to find all the parts.