Boss RIP-995
Jet-Lee
11-10-2005, 12:43 PM
I have this amp. (Boss RIP-995)
http://www.full-line-audio.com/_image/boss/rip-995.jpg
I have two Kenwood 10" Tornados (KFC-2505 NOT 2503).
http://kenwood.carclub.ru/big_img/KFC-W2505.jpg
The subs are 4ohm 600W DVC. I have the VC's wired parallel on each speaker (positives connected and negatives connected), but the speakers independent of each other. From my understanding, I now have 2ohm drivers.
How should I wire them into this amplifier for the best output. I currently have them each their own channel (1 & 2).
How much power are they getting?
Is this the best setup?
If "No", what's the best?
They are in a box similar to JL's High Output boxes.
http://www.full-line-audio.com/_image/boss/rip-995.jpg
I have two Kenwood 10" Tornados (KFC-2505 NOT 2503).
http://kenwood.carclub.ru/big_img/KFC-W2505.jpg
The subs are 4ohm 600W DVC. I have the VC's wired parallel on each speaker (positives connected and negatives connected), but the speakers independent of each other. From my understanding, I now have 2ohm drivers.
How should I wire them into this amplifier for the best output. I currently have them each their own channel (1 & 2).
How much power are they getting?
Is this the best setup?
If "No", what's the best?
They are in a box similar to JL's High Output boxes.
Jet-Lee
11-10-2005, 04:28 PM
bump....come on, 4 hours and no replies?
PaulD
11-10-2005, 08:44 PM
you are probably getting the most out of them like that ....... since the boss amp is probably not stable below 2 ohms anyway.
Automotive Network, Inc., Copyright ©2026