Integra Heater Blower Replacement

Hey All,

Can anyone provide any guidance to the procedure of removing the heater blower motor from a 1991 Honda Integra from Australia.
The Instruction manual that I have says the motor should just drop out, but the the floor is in the way!
If I don't have to remove the dash it would be great, as I done it once before, and it wasn't a lot of fun.
Any ideas or solutions would be very greatly appreciated.

J

i am replacing mine right now, and i just had to remove 3 screws and i had to kinda work the motor out, its a pretty tight fit, but it should come out. this is just the motor though, if the whole thing is being removed, that i don't know for sure but i believe the dash would have to come out

remove the dash is my advice.

I've done this twice on my 91 integra without removing the whole dash by taking the clips off of the large plastic piece directly above the heater motor and separating the two sections. It is still very hard and takes some time to work the two sections apart, but once the bottom section was separated, the motor could actually be pulled out.

pulling the dash works with EGs, EKs, and EFs not to mention, makes life alot easier. figured it would be the same on a teg.