D16z6 Into 1988 Dx

Hello Again. I Was Wondering If Anyone Had Any Pointers On The Best Way To Do This. I Have An Entire 1994 Civic(vtec), This Car Was Wrecked. I Am Wanting To Put That Engine Into My 1988 Civic Dx(dpfi). Any Pointers On Wiring, Could I Just Use The Entire 1994 Wiring Harness? Or Would You Know Any Websites That Could Help Me Out. I'd Like To Do This The Right Way And A Clean Install. Thanks Again.

here's a good write-up: http://www.angelfire.com/d20/hcivic88/4gtech_d16z6swap.html

^^ Good find

Thanks A Lot. That Is Very Helpfull. Tk

got time? got patience? me.. i will admit i got a butchered up dp to mp wiring job..but i have a whole interior exterior si harness i will eventually swap in when its niceout again. i think thats a good way to go.. but sum ppl like to simplify and thats just as good. :) keep us updated

you need to do the dpfi to mpfi conversion, you have a whole obd1 engine harness so you could use that in the conversion for the obd1 injector plugs, dist plugs, and o2 plug. buy a obd0 to obd1 conversion harness, i bought mine for 105 shipped. and then you can just use the p28 ecu. thats probably the best way.

if you do this and need help, there are several of us on here who have done the mpfi swap and converted to obd1. i myself have done both of these

I didn't see the dpfi to mpfi wiring in that link (only looked quick though). But here's a chart if it's not on there (last post of that thread): http://www.hondaswap.com/forums/index.php?showtopic=29360

hi, thanks for all the good advice, where did you buy your obd0 to obd1 conversion harness? does that repalce th entire engine wiring harness, or do you splice alittle? thanks again.