Front Hub assembly and CV/Halfshaft

Hello all,
This is the first time that I have tried this site out. I have a 2000 Grand Prix GT and just finished putting a front hub assembly on the drivers side. The installation was back breaking but everything went very smooth. When I took it for a test drive I now have a popping or cracking noice when I turn and accelerate. Can anyone help!!! Is this the half shaft or CV.

Thank you,

Make sure the axle nut is "torqued to 240 psi.

Make sure the axle nut is "torqued to 240 psi.

Max, are you sure about that?






http://i5.photobucket.com/albums/y186/lizzywiz/gtp.jpg
Thrasher CAI, DHP v1.0 PCM, SLP Headers,
3.25 SC pulley, CAIT GMAF, 2.5 DP/Hi-Flow CAT,
u-bend delete, 160 TS, ZZP Stage 1 72mm TB,
TB spacer, MSD 8.5mm wires, Autolite 103,
Goodyear Gatorback Serp. & SC Belt,
Nitto NT555R Drag Radials
1/4 ET: 13.210 sec. @ 104.490 mph
0 - 60 ft: 1.945 sec.

Sounds a little high to me, I think it's more like 180ft/lbs. In any case, make sure you tightened the spindle nut to spec.