tranny

i have a little problem. My car grinds from upshift 1-2 and downshift 3-2. It is only in 2 gear so it is not the clutch and it is fine if i start it in 2nd or shift from 1st and wait like 3 seconds and then shift in to 2nd. I took it to a shop and they said it is the sync. for 2nd (no clue what that is) and they said i need a whole new tranny and it would cost 1700 for a rebuild and about 3000 for a neew one I was just wondering if that is an ok price and if i really need a whole new transmission. thanks.

I was thinking synchro as soon as i read grind 1-2 2-3... 1700 seems about right for a base rebuild, but you can have an independent tranny shop build it up pretty good for you for probably around that or a little less than that. You dont HAVE to get a new tranny, but if you're just going to rebuild it back to stock i would just get a new one, cause after labor it's going to be about the same prices as opposed to them just pulling and replacing.

you would be better off getting one from rre

Not sure if you wanted a stock tranny or a built one. I have a stock tranny sitting in my garage from when I installed my new one. The thing is in great condition, only 45k on it. I took it out because I was looking for a lsd and found a complete tranny with one already installed. Not sure what shipping would be to you. I'm in Michigan.

Before I begin, it would be much easier to help you if you have your car info in your signature. Anyways, IMO buying a brand new tranny would be a waste of money since they are listed @ over $2000. Many used japanesse part shops will sell used one's for much cheaper. Buying a used tranny could be risky, but many of them usually give a 3 month warranty. Keep in mind that it takes aprox. 4hrs to remove tranny and 3 to 4hrs to install. If your AWD then it will take longer. You are looking @ a minimum of 7-8hrs of labour charges (just for swapping) not including parts. Explore your options.