exhaust

I'm about to go install my exhaust tomorrow. I'm just curious as if anyone who installed their exhaust had to replace their rubber exhaust hangers. I had to do it on my mustang, but I'd like to save the twenty bucks and just use the existing ones. So anyone had to replace them, or are they usually pretty good?

What kind of exhaust is it? I dont think you need to replace the hangers unless the exhaust have the hangers in a diff location. Also u should run your car around the block and then take off your old exhaust because this would make it easyer to remove the bolts. Good luck and congrats on your exhaust.

well the only reason I had to replace the ones on my mustang is because they were all messed up and extremely hard to get off the stock exhaust without having to cut. I was wondering if it was the same situation here.

I just kept and used my old ones.

Tip: WD40 helps the exhaust slide out the hangers

The old ones will work with the new exhaust. I actually only used about 1/2 of the ones there. It still holds up good. The ones you dont use you can take the bolts out and take off the mounts. Weight reduction. Very little.