87 S10 Blazer Wont Go in Gear

I've searched the threads but haven't found an answer to this one....

'87 S10 Blazer 2.8L 4WD - Will not go into gear when it's running. I've replaced:

Pilot Bearing
Clutch
Throw Out Bearing
Slave Cylinder
Master Cylinder
Hydraulic hose between Master and Slave

I've bled it till I'm blue in the face and it still wont go into gear when its running. Anybody know what I should try next? Chiltons manual has nothing about troubleshooting and I'm stuck. Thanks.

try this turn the truck off put the trans in first then push in the clutch and try to start if the truck jumps foward you still have air in the lines if not and it starts fine see what happens when you let out the clutch

also some clutches will fit and engine but wont work too thick thin what ever the case double check to make sure you have the right kit

Thanks, I'll give it a whirl.

Thanks, I'll give it a whirl.
Try giving this site a whirl
http://p207.ezboard.com/bs10extremists