This is what i need right?

I already have something sorta resembeling this, but i need an aswer REALLY fast, as i want to get it asap and get this fixed.
I just need the drivers side mirror fixed, not the whole assembly, the mirror is cracked, this is what i need right?
Its a 92 RS, not electric controls, this will work right?
http://cgi.ebay.com/ebaymotors/82-92-CAMARO-FIREBIRD-DRIVER-SIDE-DOOR-MIRROR-GLASS_W0QQcmdZViewItemQQcategoryZ33649QQitemZ79899 56231QQrdZ1

Also, how do i get this thing on, not sure how i pop off the front mirror part and get all the cables down inside and everything, i can worry about that later, just need to make sure this is the right piece...

If you take the trim piece off the inside interior you will see 3 nuts holding on the mirror assembly to the car. Once you remove it. You will be able to access it from the back and pop it out and yes as long as they are both manual mirror's it will work since they used the same one since 82.

Hm, I'd think so, doesnt look like it has any cables to it. So i'd try it, heck contact the guy, to make sure.

ok thanks a lot guys, what are some things i should ask him just to be sure, just say hey, this will work for my 92 rs right?

Yes because like John said they used the same thing the whole generation.

awsome, i hope this is what i need, just wrecked into a damn mailbox today backing up, and pretty much trashed the whole side of my car, does anyone also know what those little things on the doors are called, close to the bottom that stick out, they look all aerodynamic and such, i ripped mine pretty much off, dented my door up pretty bad, going to go to the body shop and get the dents out, like to just put a new door thing on (what are they called...) mite as well start searching ebay for one of them also...
My poor baby has been through some tough stuff lately, definatly going to start babying her....

You mean side skirts? You can look around over at www.hawksthirdgenparts.com Look around for them, they're cheaper used of course.

Guys!
I could just get this instead right?
Found JUST the glass at hawks 3rd gen, thats all i need really...
http://www.hawksthirdgenparts.com/inc/pdetail?v=1&pid=8719

Should be fine right? Just take the pieces of the broken glass out, and put this new one in?

I would make sure its not power glass, cause he says it includes wiring?. which to me sounds like it came from a power unit but he could mean the hose.

Well, i just bought just the glass, from hawks, just bought the left side, that is what the drivers side is right? a couple minutes again, $19 something for just the glass, this should be just fine... all i have to do is pick the glass pieces off the mount and use the mounting tape that comes with this to put it back on right?

I would make sure its not power glass, cause he says it includes wiring?. which to me sounds like it came from a power unit but he could mean the hose.

the glass shouldnt have any wires... lol, if it does it might be heated... lol, the glass doesnt move the base moves... lol, the thing you mount the glass to, lol, so any glasswill work it dont matter, but if it comes with wires it might be heated? i donno, but wires or no wires it shouldnt make a diffrence, it should still work none the less.

Like i said, im not going with the ebay guy anymore, i just bought a glass piece at hawks for $19 just now, that should be just fine correct?
Also, another quik question wile you guys are here, body shops can pull out small dents right? I have about 3 of them, how much should that run for all of them and to get the side skirt back on?

ummm you shoulda bout the one from ebay, chaper and you replace more parts that might need it. thats what i woulda done ya know? more for less but whatever hope it works out good.

Like i said, im not going with the ebay guy anymore, i just bought a glass piece at hawks for $19 just now, that should be just fine correct?
Also, another quik question wile you guys are here, body shops can pull out small dents right? I have about 3 of them, how much should that run for all of them and to get the side skirt back on?

yes, the glass should be fine, lol, you might wanna try something like dent king... its like 20 bucks and will pull out alot of dents... as far as paying a shop to do it, prices would vary depening on where you are, and how greedy they are. (also would depend on how big the dents are to)