sensor

the sensor that goes into the intake isnt fitting properly into my new intake any ideas?? thanks in advance

get a Q-tip and dab a small amout of oil just behind the opening on the IAT sensor where its just all plastic. Insert into the gromet and carefully twist from side to side and push it into place. If no luck there, get a screw driver that has a round shaft and run that around the inner part of the gromet to make sure its fully seated ( i had to do this with mine ) then try the previous step again. If still no luck read next step.

-Remove rubber gromet.
-grab cordless drill and bits.
-find drill bit thats a smidge larger and widen the hole only a very little bit.
-make sure to remove any shavings that may have gotten into the intake.
-reinstall everything to the first process.

thanks