Programming a new remote??? Help

Hi guys,

Can anyone tell me the procedure to program a new keyless remote to a 2002 Escalade?

Thanks

you can try this company: http://www.keylessride.com

they were able to reprogram my remote for a lot less money than the dealer wanted.

-bb

all you do is shut the doors turn on key two times leave on and then hold the new remote lock and unlock buttons at the same time for 30 seconds and voila i do it all day everyday thios works

Note: Before starting this procedure, ALL transmitters must be present.


Turn Ignition Switch to OFF.

Ground pin 4 (BLK-Ground) to pin 8 (BLK/WHT-Keyless Entry Program Enable Signal) of the Data Link Communications Connector (a.k.a. DLC, Under the left-hand side of the instrument panel, left-hand side of the steering column, mounted to the bottom of the knee bolster). The receiver will respond by locking and unlocking the doors, and activating the liftgate window release (if equipped) within 2 seconds.

Press and hold the LOCK and UNLOCK buttons simultaneously on the first transmitter to be programmed until the locks cycle (approximately 10 seconds).

Repeat step for up to four total transmitters to be programmed (if available). The receiver will respond by locking and unlocking the doors and activating the liftgate window release (if equipped) within 2 seconds.

Remove the ground applied to the DLC.
Lock and unlock the doors in order to verify the transmitter operation.

Activate the rear window release in order to verify the transmitter operation. Repeat programming procedure or replace transmitters as necessary.