back seat speakers

whats the best way to genew speakers with a screw on grill will that work or do i have to take out the side pannelst the speakers out in the back seatsi was thinkning about getting a box cutting knife and cuting the gril out and unscrewing the speakering and placing my

translation? :screwy:

translation? :screwy:

lmfao!!! :lol2:

what are u asking, if u clear this question up ill be able to help u, i have done speaker work on camaros.

are you asking how to modify the sail panels on the rear speakers so that you can see the speakers? The way im doing it is as follows. I pulled the cloth off of the cardboard panel, installed the speaker and then installed the carboard panel over it. then used an exacto knife to cut it to the correct size so that you can still install the screws throught the panel and the top screws of the speaker. then recover the panel in the right color fabric. Then install it as follows. you will need six screws for the intall. Install the speaker grill to the sale panel with two screws through the lower two screw holes. then install the sail panel over the speaker which is also held in by the lower two bolt holes. then use the remaining two screws to go all the way through the speaker grill, sail panel, and top two screw holes on the speaker itself. this should be the answer to what i think youre asking.

although i stress that measurements and fitting is critical to makeing this work. so doubble and tripple check everything before you start doing anything permanent. Also, i found it was usefull to get a second pair of sail panels to do my preliminary test fittings on so i didnt ruin my originals.