2001 Blazer console and stereo removal
mgutier
06-13-2005, 10:25 PM
I have almost taken the console off to get to my delco radio but the wires that go to my lights, 4 wheel drive controls, etc are in the way and do not want to come out of their sockets -- how do I remove them. Also how do I remove the delco radio (I am installing a ipod adaptor into the aux-cd changer port), the wires on the radio seem to be short because the radio doesnt move that much once I unscrew everything. Sorry, but one last question; where do I drop the cable which goes into my ipod? Is there and opening under the radio somewhere to have the wire come out.
Matt
Matt
Booch
06-17-2005, 01:00 AM
Harnesses should just unclip from the switches that are mounted in the part of the dash you are removing; each one should have a clip on the side that you push in and pull the harness out.
On my 2002, the radio pulls out after you remove the 3 fasteners holding it in place; don't know if your 2001 is different or not.
Lastly, since this wire is just a signal from the Ipod to the radio (i.e. not a power wire that could ground out), you can snake the wire out anywhere you want; you have to decide where you want the Ipod to sit first.
Hope this helps!
On my 2002, the radio pulls out after you remove the 3 fasteners holding it in place; don't know if your 2001 is different or not.
Lastly, since this wire is just a signal from the Ipod to the radio (i.e. not a power wire that could ground out), you can snake the wire out anywhere you want; you have to decide where you want the Ipod to sit first.
Hope this helps!
Automotive Network, Inc., Copyright ©2025
