wastegate pipe?

Hey all just got my exhaust manifold today and i was wondering how i go about puting the wastegate tube in. What size pipe is recomended and where would i bring this to be cut and welded. Or if there is an alternative place to put the wastegate please let me know. i though about the o2 housing but can the stock 3g housing be used?

Are you running forced induction? If not. I dont think there is a point in having a wastegate. Am i right guys?

Are you running forced induction? If not. I dont think there is a point in having a wastegate. Am i right guys?

he is putting together a custom turbo kit if i remember correctly

yes iam puttiing together a custom turbo and i have almost all my pieces now and i am ready to begin the prep for the actuall install. i would like to run the wastegate off the manifold and i would like to know what type of tubing should i use. i am going to put it off the number 1 runner and i just need some info on tubing and possibly how much it might cost to have this drilled and welded on.


thanks

are you wanting to know where to put the dump tube?

Here i will show you a picture ofwhat iam trying to acomplish i understand where i want to put the tube i just need to know what thickness i should use and how much it might cost me to have the hole drilled and the tube/flange welded on.

heres the pic ( i know this is possibly the most hated seller on ebay but this is what i am talking about)
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7978671420&category=33742

just use 304 stainless steel(might be expensive though). couldnt tell you how much it would cost somebody to do it since it varies from shop to shop

Did you do a 4g63 swap into a 3G?

Did you do a 4g63 swap into a 3G?

No he didn't but 2G exhaust manifolds will bolt right up to the 4g64 in his car.

Did you do a 4g63 swap into a 3G?

not necessary

is it the v6 or 4

is it the v6 or 4

4cyl