Need some help/advice.

Im trying to switch out the clutch on my 00 Camaro 3800. Well, i havent gotten very far, just removed a small crossmember and the front end torqe arm. The major problem im having is that my bolts on my drive shaft are extremly tight, and i have no air tools. If i can get my drive shaft off, then out comes the tranny and pop in the clutch and im done...but i cant..any tips or pointers?

are you using 1/2in. tools or 3/8? have you tried using a breaker bar?

Have both, and they both give same results, as for the breaker bar i havent tried it yet. they just seem..oddly tight. The problem might be they havent been off in maybe 2 years...

Ok i solved that problem and a step away from dropping the tranny, but my frickin shifter ball is stuck. no screws, no nothing...it just spins...i tried pulling it...nothing...twisting it..nothing...Anything????

Is there a clip holding it in place?

Solved the whole situtation, trannys now off to the side, gotta wait for tommorow to finsh because of the resufacing of the flywheel....BY THE BY PEOPLE: Trannys are a BIT** to get off the first time, i really mean first time. none of the bolts are broken in..blah blah blah..it just sucks...

LOL i'm doing a T56 conversion in a friends 94 Z in my parking lot at my apt lol....gonna be a blast! LOL

William

have fun with that, get used to the smell of asphalt

now thats a project! good luck man