Blinkers

ok so when i go to put my blinkers on they go on but they dont blink the light both inside and out stays solid, anyone know what the problem is?

check the flasher solenoid deal thats in your fuse box under your dash, driver side. I beleive its the big round canister, about the size of a half dollar. That went out in my f-150 (90) and it would do that. Its like $3-4 at autozone IF thats the problem. Let me know if that works.

thanks alot ill check it out and see if thats the problem

damn, i changed the flasher and that wasnt the problem, my hazards work, they flash jus my blinkers dont, im guessing its the switch

I've got the same problem. I checked all the fuses and replaced the flasher solenoid, but still no turn sgnals. The four way hazzard lights work fine. Any ideas as to where I can get a new or used switch? The local junkyards don't have any. Also, have you heard of anythind else that could cause this?

Thanks much.

Check your bulbs. Typically if one of your bulbs is bad, it will cause a chain reaction resulting in what you describe.

I discovered that my ignition switch had failed; I replaced it and the problems vanished. A new ignition cost $12.00 at NAPA.

Good Luck!

ok found the problem, it was the other flasher in back of the radio.