Bubbles inside decal

I got a 2002 WRX WRC version. After I put on the side decals, I notice there are some bubbles. Is it possible to fix it with microsol?

use a needle to make a small hole in the buble and use microsol to soften it

Yeah, put a drop of decal solvent over the bubble, pop it with a very sharp knife or pin, the smaller the hole the better, wait a few seconds for the solvent to draw in, and carefully blot the moisture out so the decal is flat and let it fully dry before touching it again... - Mark

I thought that Microsol melted the tamiya decals!?