need help fast

im going to be changing my transfer case this weekand and wuz wondering how hard it would be to take off the old one and put on the new one? i heard it wuz easy but i wanted to get another opinion before i started on it thanks for any input! :slap:

With a good floor jack, its really not tough. Drain the TC. Remove front and rear drive lines. Set the jack under the TC. Remove sheild and cross member. Remove speedo gear, position sensor, vent tube and wire clamps. Remove shift linkage. Remove six bolts to transmission. Remove TC. While you are here, go ahead and change the trans output seal! Reverse procedure to install.

With a good floor jack, its really not tough. Drain the TC. Remove front and rear drive lines. Set the jack under the TC. Remove sheild and cross member. Remove speedo gear, position sensor, vent tube and wire clamps. Remove shift linkage. Remove six bolts to transmission. Remove TC. While you are here, go ahead and change the trans output seal! Reverse procedure to install.
thanks for the input :slap:

So? How did it go?

So? How did it go?
i didnt get a chance to do it the weather wasnt to good in asheboro and i have lazy freinds im going to try it this weekand will let you know how it went. :cheers:

i didnt get a chance to do it the weather wasnt to good in asheboro and i have lazy freinds im going to try it this weekand will let you know how it went. :cheers:
i did that yesterday and the other t.c wuz differant so im going today to get my second one it wuzent that hard i wonder if i put the other one on e bay if it would sell?

Shipping is pricey. What model is the old one?

Shipping is pricey. What model is the old one?
i have a couple of jeeps of my own but i figured all the transfer cases were the same so ill just take it off a 4.0 :swear:

Nope...three different models with a couple of configurations between them.

Nope...three different models with a couple of configurations between them.
thanks for the info :22yikes: