Engine Swap
Seamore_SW20
04-15-2005, 09:27 PM
Hello peoples
I was just wonderingg if a C30A or a C32B would be a direct fit into a Toyota MR2 or if i would need to screw around with it. Any help would be much appreciated.
:confused: :confused: :confused:
I was just wonderingg if a C30A or a C32B would be a direct fit into a Toyota MR2 or if i would need to screw around with it. Any help would be much appreciated.
:confused: :confused: :confused:
yellownsx
04-22-2005, 11:18 PM
Lets see...where do I start? An NSX motor w/o trans is over $20,000
closer to $25k if memory serves. it will only bolt up to an NSX trans. I never did find out what that costs. Then there is the exaust! Lets assume, just for a minute, that it would fit in the car. (which it doesn't) you need the electronics to run it and keep it from going over 8000rpm's. There is also no place to hook up power steering as in the NSX it is electronic also (expensive and pain in the @$$). It would be very cool if you could get it all to work but it would be cheaper to buy a used NSX. (sorry)
closer to $25k if memory serves. it will only bolt up to an NSX trans. I never did find out what that costs. Then there is the exaust! Lets assume, just for a minute, that it would fit in the car. (which it doesn't) you need the electronics to run it and keep it from going over 8000rpm's. There is also no place to hook up power steering as in the NSX it is electronic also (expensive and pain in the @$$). It would be very cool if you could get it all to work but it would be cheaper to buy a used NSX. (sorry)
ediddy310
07-20-2005, 04:45 AM
yup I concur....=) you can get a used clean nsx motor for about $5500.....check out daliracing.com and scienceofspeed.com
Automotive Network, Inc., Copyright ©2026