how do u get this piece off the dash???

http://i3.photobucket.com/albums/y91/hondacivic4358/th_afint.jpg (http://i3.photobucket.com/albums/y91/hondacivic4358/afint.jpg)



ive tried and tried and i even took my glove box off to try to get behind it and get to any screws i couldnt see, but still no luck!!!!! :banghead: its frustrating. it feel like it doesnt just pop off and i dont want to break it. i couldnt find any screw hold under or behind either.

Are you talkin about the center vent ?

yeah

looks like thats a CRX, i have a H/B.
But I'd say you might have to take out the whole center console:confused:

In the hatch it just pops out verry carefully.

Verrrry.

hmmm...any tips? should i use a flat head screw driver?

do you have a heat gun, or a blow dryer that puts out a good bit of heat. If so heat it up before you pry on it so it's not as brittle.

yeah i have a heat gun. i will try that. hopefully theres no screws or anything that im missing because i dont wanna snap this bitch.

check for any screws on the side...

the crx if i am right dosn't have screw but i am not sure about a hb?

how did u get the those side heat vents out???, i tried and tired and cracked one of them

very very carefully, i just took 2 medium sized flatheads and just kinda shimmied em outta there. ha. shimmied. :iceslolan

all vents just pry right out. be careful, as mentioned, and use a flathead screwdriver and go around the entire thing prying a little at a time to feel for exactly where the tabs are and making sure not to break them. the dash around the vent is pliable. the plastic parts of the vents are brittle, especially if they're 15 years old. you should be able to get most anything behind the vents with ease since the dash is usually still soft.