Pulling boat in Overdrive ?
DickyDoo
03-25-2005, 10:47 AM
I have always been told to never pull anything in OD. A buddy of mine said that it want hurt to pull a boat(16' fiberglass ).I think he is wrong. What do yall think?
broughy84
03-25-2005, 11:05 AM
NEVER pull something this heavy in OD. I pull LawnMowers and stuff in OD, but NEVER something that heavy. You will cause your tranny to start slipping!
'97ventureowner
03-25-2005, 03:35 PM
I've been told the same thing. I don't use OD when I'm towing something or have a load in the bed of the truck. I haul a lot of mulch, topsoil, stone etc. and have to "consciously" shift the lever past OD whenever I do so.
J-Ri
03-25-2005, 10:13 PM
Definately don't pull it in OD! You save such a small amount of gas with OD on. There is no way saving $3 is worth possibly spending thousands on a tranny rebuild. If he doesn't believe you, or us, tell him to look in the owners manual.
Tall
03-26-2005, 06:21 AM
I am not an OD fan at all. I really only use it on the freeways. If I am traveling 55mph+ for long periods of time... But for around town, I just use drive.
And it is not good for tranny to be in OD when pulling... stresses everything out.
And it is not good for tranny to be in OD when pulling... stresses everything out.
95chevy
03-27-2005, 01:57 PM
My 95 only has the readings: P-R-N-OD-3-2-1. So if I am hauling something or pulling something what should i use?
J-Ri
03-27-2005, 05:18 PM
if the OD is a D with a square circle around it, then use 3. I havn't seen 1,2,3,D in anything but a car, but maybe some trucks have that too. Drive is almost always 3rd gear on an automatic transmission.
'97ventureowner
03-27-2005, 09:47 PM
My 95 only has the readings: P-R-N-OD-3-2-1. So if I am hauling something or pulling something what should i use?
My '94 has that setup and I use "3" when towing or hauling a load.
My '94 has that setup and I use "3" when towing or hauling a load.
broughy84
03-28-2005, 07:14 AM
my 88 has p-r-n-od-d-2-1 -- use d
my 96 has p-r-n-od-3-2-1 -- use 3
my 96 has p-r-n-od-3-2-1 -- use 3
lacarman
08-09-2005, 09:18 AM
I have pulled cross country pulling trucks and cars with no problem.
I use 3rd gear until I am at about 70-75 then I shift into OD.
If I run into a hill or traffic I downshift to 3rd until I can regain momentum.
The key is dont put heavy stress on the tranny when pulling in OD. When your going 75 on the highway at a steady speed, without hills, it puts very little stress on the tranny.
Mabye I have been lucky, just my 2 cents.
I use 3rd gear until I am at about 70-75 then I shift into OD.
If I run into a hill or traffic I downshift to 3rd until I can regain momentum.
The key is dont put heavy stress on the tranny when pulling in OD. When your going 75 on the highway at a steady speed, without hills, it puts very little stress on the tranny.
Mabye I have been lucky, just my 2 cents.
Snowgoer05
08-14-2005, 07:17 PM
kiss that tranny good bye
Automotive Network, Inc., Copyright ©2025
