Wiring problem/question

about a month ago, i wired some led's in my ground effects for additional turn signal light. I grounded the led to the turn signal wire and powered it to a fuse in my fuse box. It worked fine, when i turned on my turn signal, it would alternate between the bumper light and the led's in the ground effects. During the winter, the wires got ripped out of the back of a couple led's from the snow so i unhooked it from the fuse.

Recently i tried to do it again, but the passenger side wont work. I grounded it to the same part where i spliced it before, but it wont work. The drivers side will work though. All of the turn signals, parking lights and stuff work properly... but i cant get the leds to work anymore on the passanger side

any help would be appreciated
~DK

resistor could be burnt (or do your led's have the resistor built in?) have you tried taking the good led on the driver's side and putting it in the passenger?

its not the led, its something with the wiring, because i tried hooking the same led up to both sides, it worked on the drivers side, but when i put it on the passengers side there was nothing

Could be the socket itself.. Follow the hot for that back to where it's supposed to get power from and use a multimeter to check continuity.