2.2 to a 4.3 vortec

If anybody can help it would be greatly apeciated i am wanting to pull my 2.2 liter 4 cylinder motor out my 95 s-10 and drop a 4.3 liter vortec into it and i was wanting to know what i would have to replace to do it properly.

It'll be pretty well the same cost to switch to a 350 V8, and then your truck has a higher re-sale.

buy a written of full sized truck with a 350... preferably around the same year as yours. Make sure that they haven't munched the front end too bad
I believe that you'll need custom motor mounts and someone can tell you where to get them when the time is right
Then take your time transfering the 350, electronics if required, and the transmission from one to the other

Mark everything before you remove it, and try drawing yourself a small map of all the hoses, ect

When your done sell all your un-needed parts. You'll make more selling them piece by piece, but it's nice getting the mess off your yard asap if someone offers you a package price.

I know that it's a 4x4, and converted from a 2.8L S-10 Blazer but this site will give you a look at what's required
http://hickory.engr.utk.edu/~gpowell/2.html

Parts needed for you to swap to a 4.3

Engine
Engine Harness
ECM
Transmission (you're existing transmission will not bolt up)
Drive Shaft
Motor mounts
Y-pipe
Accessories (alt, ac, et-al)

Parts needed for the v8 swap

Engine
Engine Harness
ECM
Transmission (you're existing transmission will not bolt up)
Drive Shaft
Motor mounts (2.8 conversion mounts)
Y-pipe
exaust pipe
lt1 conversion headers
Conversion oil Pan
Accessories (alt, ac, et-al)
Depending on the motor, hammer back the firewall)
E-fan
Radiator

Parts needed for you to swap to a 4.3

Engine
Engine Harness
ECM
Transmission (you're existing transmission will not bolt up)
Drive Shaft
Motor mounts
Y-pipe
Accessories (alt, ac, et-al)

Parts needed for the v8 swap

Engine
Engine Harness
ECM
Transmission (you're existing transmission will not bolt up)
Drive Shaft
Motor mounts (2.8 conversion mounts)
Y-pipe
exaust pipe
lt1 conversion headers
Conversion oil Pan
Accessories (alt, ac, et-al)
Depending on the motor, hammer back the firewall)
E-fan
Radiator

Good List rlith. I can tell that you've done this before.

I've helped to a couple. I'm doing my own in may (5.7 vortec from a 99 escalade)...