1994 jimmy dash lights

How do you get to the dash lights? The one on the right is still working, the one on the left behind speed ommiter is out.
Thanks in advance for any advise.

The ones illuminating the dash cluster?

You have to rip apart the dash, & remove the cluster from the
dash.To get at it you have to take out the heating, a/c, defrost
and 4x4 controls, light switch controls, etc.

Basically, all you need to tak out the control switches
are flathead and phillips screwdrivers, before unpluging and
uncliping the connections.. Then you will
need a deep socket 10mm to get at the nuts holding
down the plastic thing surrounding the cluster, & the cluster itself.
While doing this dont forget there is a gear indicator cable
than runs from the bottem of the cluster and clips on to the
steering collum.

YOur going to have to remove a handfull of little pannels below
the cluster and steering wheelto get at it... If your going to remove
it completely

Mounted on a blue knob, there are quarter turn,
screw in bulbs in the back. They might be a dealer item?

The ones illuminating the dash cluster?

You have to rip apart the dash, & remove the cluster from the
dash.To get at it you have to take out the heating, a/c, defrost
and 4x4 controls, light switch controls, etc.

Basically, all you need to tak out the control switches
are flathead and phillips screwdrivers, before unpluging and
uncliping the connections.. Then you will
need a deep socket 10mm to get at the nuts holding
down the plastic thing surrounding the cluster, & the cluster itself.
While doing this dont forget there is a gear indicator cable
than runs from the bottem of the cluster and clips on to the
steering collum.

YOur going to have to remove a handfull of little pannels below
the cluster and steering wheelto get at it... If your going to remove
it completely

Mounted on a blue knob, there are quarter turn,
screw in bulbs in the back. They might be a dealer item?

Thank you so much. I had no idea where to start.

take the lower garnish panels and heater duct out, you may be able to get your hand up behind the dash that way and just turn the bulb socket conterclockwise 1/4 turn pull bulb and socket out. bring unit to napa they will have a replacement peanut bulb.

Thanks. That sounds easier than the other.

Thanks. That sounds easier than the other.

Pull the cluster, much easier then trying to get your hand up there... Also take a look at this thread regarding replacement bulbs with clusters. This will for the most part apply to yours as well.

Ok. Thanks.

Hmm i dont see how you could get your hand behind there without unbolting it or taking almost everything out. It cluster is bolted against another panel where
the electical connectors are located.

Have you done this before? (I'm just a "dumb" girl not sure where to start.) Also, have you changed out the window motors? Saw several on ebay. I've got to get this truck ready by May for my son. Thanks.

Have you done this before? (I'm just a "dumb" girl not sure where to start.) Also, have you changed out the window motors? Saw several on ebay. I've got to get this truck ready by May for my son. Thanks.

For a good how-to on the window motors, look here http://www.usedpartscentral.com/tech/page1.htm

Thank you.