93 Caravan Transmission problems
krumrei
03-06-2005, 09:02 AM
Ok,
My issue is this. I have a 3.3 V6 93 caravan.
I recently replaced the Solonoid for the tranny, flushed everything out, everything looks fine, but the transmission will sometimes shift fine, but aother times, it will only go into 2 gear, until I pull over, restart the motor like 3-6 times and then it will finally go into low and then shift normally.
Sometimes when I start the damn thing will not even go into gear. I check the valve body for dirt, clean, replaced the solonoid, does the same damn thing. Check and clean all the sensors with electrical cleaner.
I am thinking it maybe an electrical issue/computer.
Anyone else have this probelm?
My issue is this. I have a 3.3 V6 93 caravan.
I recently replaced the Solonoid for the tranny, flushed everything out, everything looks fine, but the transmission will sometimes shift fine, but aother times, it will only go into 2 gear, until I pull over, restart the motor like 3-6 times and then it will finally go into low and then shift normally.
Sometimes when I start the damn thing will not even go into gear. I check the valve body for dirt, clean, replaced the solonoid, does the same damn thing. Check and clean all the sensors with electrical cleaner.
I am thinking it maybe an electrical issue/computer.
Anyone else have this probelm?
rebuilder
03-31-2005, 01:26 PM
Ok,
My issue is this. I have a 3.3 V6 93 caravan.
I recently replaced the Solonoid for the tranny, flushed everything out, everything looks fine, but the transmission will sometimes shift fine, but aother times, it will only go into 2 gear, until I pull over, restart the motor like 3-6 times and then it will finally go into low and then shift normally.
Sometimes when I start the damn thing will not even go into gear. I check the valve body for dirt, clean, replaced the solonoid, does the same damn thing. Check and clean all the sensors with electrical cleaner.
I am thinking it maybe an electrical issue/computer.
Anyone else have this probelm?
for your van not to go in gear is a mechanical problem,unless you have no fluid in it.when a chrysler trans goes into limp in the realy is turned of and line pressure is at maximum.They will always go in gear if there is an electrical problem.
My issue is this. I have a 3.3 V6 93 caravan.
I recently replaced the Solonoid for the tranny, flushed everything out, everything looks fine, but the transmission will sometimes shift fine, but aother times, it will only go into 2 gear, until I pull over, restart the motor like 3-6 times and then it will finally go into low and then shift normally.
Sometimes when I start the damn thing will not even go into gear. I check the valve body for dirt, clean, replaced the solonoid, does the same damn thing. Check and clean all the sensors with electrical cleaner.
I am thinking it maybe an electrical issue/computer.
Anyone else have this probelm?
for your van not to go in gear is a mechanical problem,unless you have no fluid in it.when a chrysler trans goes into limp in the realy is turned of and line pressure is at maximum.They will always go in gear if there is an electrical problem.
Automotive Network, Inc., Copyright ©2025
