2000 Rodeo Stalls When stopping
rosemari
03-03-2005, 07:33 AM
My 2000 rodeo stalls a lot, usually whenever i go to stop or am slowing down to pull into a parking stop. It idles a little rough, but rarely stalls when idling, just when driving through traffic lights for the most part. I brought it to a garage and they replaced the throttle valve assembly and the sparkplugs. The codes have been all checked and nothing could be found wrong. Any ideas?
amigo-2k
03-03-2005, 08:43 AM
sounds like a classic leaking intake manafold gasket:
http://isuzufaq.ibctech.ca/#faq5
if you are the orginal owner Isuzu will replace it for free if you are under the 10yr/120k
If you are the second owner they will replace it for 5yr/60k.
http://isuzufaq.ibctech.ca/#faq5
if you are the orginal owner Isuzu will replace it for free if you are under the 10yr/120k
If you are the second owner they will replace it for 5yr/60k.
rosemari
03-07-2005, 08:39 AM
The first thing i had done to the car was replacing the intake manafold gasket. Any other thoughts? thanks.
amigo-2k
03-07-2005, 08:41 AM
I wounder if they used the new torque spec of 13lbs.
Also, have you had your EGR and EGR port cleaned?
Also, have you had your EGR and EGR port cleaned?
sven8
03-17-2005, 02:22 PM
I have had the same problem for a while now also- the SUV will stall ocassionaly when idling or stoping, and also generally requires starting several times, it generally stalls after the first start.
I also had the intake manifold gasket replaced. It seemed to help a little bit, but now, two months later it is surely no better than before. [Please explain further about the new 13lb torque spec- what was the old spec?]
I have no error codes. I tried cleaning the EGR and the EGR tube with carb cleaner. I suspected that the EGR was stuck closed, as it does seem to stick in that possition a bit. I don't know if the electric EGR (which has like 6 contacts) gives position feedback to the computer to tell if it is stuck closed and wether this would necessarily produce an error code.
Anyway, I don't know what to do next.
Rosemari, let me know what you find out.
Anyone have any more ideas?
I also had the intake manifold gasket replaced. It seemed to help a little bit, but now, two months later it is surely no better than before. [Please explain further about the new 13lb torque spec- what was the old spec?]
I have no error codes. I tried cleaning the EGR and the EGR tube with carb cleaner. I suspected that the EGR was stuck closed, as it does seem to stick in that possition a bit. I don't know if the electric EGR (which has like 6 contacts) gives position feedback to the computer to tell if it is stuck closed and wether this would necessarily produce an error code.
Anyway, I don't know what to do next.
Rosemari, let me know what you find out.
Anyone have any more ideas?
amigo-2k
03-17-2005, 03:24 PM
have you done a general tune up?
Automotive Network, Inc., Copyright ©2026
