Codes

hey fellas,
I'm getting P0125 & P0141.
I know one of them is the O2 sensor, and i think the other one is a coolant deal.
Can someone confirm this for me.
Also If it is the coolant code, does anyone know how to change it or fix it or do what ever on a 96 Z-24 2.4 AT.
Thanks

hey fellas,
I'm getting P0125 & P0141.
I know one of them is the O2 sensor, and i think the other one is a coolant deal.
Can someone confirm this for me.
Also If it is the coolant code, does anyone know how to change it or fix it or do what ever on a 96 Z-24 2.4 AT.
Thanks


PO125 - ECT (Engine Coolant Temp) sensor, excessive closed loop time! Needs a new one, only cheap and an easy change!

PO141 - O2 Sensor Circuit fault sensor 2!

PO125 - ECT (Engine Coolant Temp) sensor, excessive closed loop time! Needs a new one, only cheap and an easy change!

PO141 - O2 Sensor Circuit fault sensor 2!
where is the ECT sensor at on the 96 z-24?

where is the ECT sensor at on the 96 z-24?
I'll ask again, does anyone know where the sensor is at on the 96 Z-24?

I'll ask again, does anyone know where the sensor is at on the 96 Z-24?

Just next to the pipe running from the rad to the block!

is it a sensor like the O2, or is it a quick connect?, not sure what i'm looking for here.

it is on the side where the coolent goes into the motor and it is fairly easy to replace. so looking at the motor on the right. on top.

Quick release yes, not sure on bolt size! Coolant will come out the hole though so have a rag ready beneath the hole and plug it while you get the other ready. Plumbers sealing tape on the thread is a good idea and do it while the motor is cold!