is this a waste of time

is putting boltons a waste of time on a d16a6 or can it be some what ok i was going to go turbo but just dont have the money and 1500 is anuff to get a few boltons. but is the d16a6 a dead horse?

um if you shop right 1500 is enough to turbo it!

well help me give some links

Civic EX VTEC 1.6L
1992-1995
cast manif. w/ fuel mgt.
11550021A
$1394.99

http://www.city-speed.com/webstore/eng_GreddyTurbos.html
The one for the D16Z6 will work perfectly for you. the wiring for the emanage will take you about 5mins to figure out if you have a wirng diagram for your civic. If not Im sure one of us at that time can get you one if you do not have one.
BTW its 1460 shipped.

Cjz89civic thank you and what kinda gane do you think i will feel with that setup do you think i can brake in to the 14's with that and 2.5in catback

ya out of the box you should be in the high 14's. With intercooler and tuning you can get that set up into the 13's

This looks like a good setup for a beginner with a stock motor. Ask him for some better pics.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7956877933&category=33742

what kinda engine management do i need

if you want to turbo check out www.homemadeturbo.com and www.d-series.org they have a great FI board and read

yes d16a6 can make great power, just need to know how to build it right. With turbo and internal work, you could probably go 200whp+ down the road with proper tuning

and please please never neglect fuel management. Proper fuel:air ratio helps to prevent detonation, along with higher octane gas.

where can i find a used d16a6 motor and i looked on ebay

risingsunengines.com - to get the motor and ship it to my house is around $700

thanks

try www.cjee.com for a motor too