Reset Check Engine Light
LeslieR
02-21-2005, 01:59 PM
I just replaced the two Oxygen sensors on my Contour after getting codes that they both needed to be replaced. Is there a way for me to reset my check engine light? It is still on.
beyondloadedSE
02-21-2005, 02:42 PM
The easiest way if you dont have an OBD-II scanner, is just to disconnect the battery. Kinda sucks that you reinput all your radio stations since the whole power supply is wiped, but it does the job.
surnamefirstname
09-25-2005, 09:27 PM
Check your manual - there's two fuses in the power distribution box (I think they're #4 and #11- but double check), and pulling them for 10 mins should clear your codes without any radio reprogramming req'd.
beyondloadedSE
09-26-2005, 12:35 PM
holy old post batman!
redmachinelover
10-04-2005, 11:54 AM
I just replaced the two Oxygen sensors on my Contour after getting codes that they both needed to be replaced. Is there a way for me to reset my check engine light? It is still on.
Hello
Was changing the O2 sensors difficult. I am getting the same service engine light issue on bank2 sensor. Acording to code reader.
Where did you buy the parts? How expensive?
And disconnecting the battery for 10 minutes does reset the check engine light, though you will have to reprogram your radio stations as others have stated.
Thanks for the feedback
Hello
Was changing the O2 sensors difficult. I am getting the same service engine light issue on bank2 sensor. Acording to code reader.
Where did you buy the parts? How expensive?
And disconnecting the battery for 10 minutes does reset the check engine light, though you will have to reprogram your radio stations as others have stated.
Thanks for the feedback
Automotive Network, Inc., Copyright ©2025