Our Community is over 1 Million Strong. Join Us.

Grand Future Air Dried Beef Dog Food
Air Dried Dog Food | Real Beef

Grain-Free, Zero Fillers


97 Blazer HELP!


afelix9137
02-20-2005, 09:38 AM
Blazer has 158,000 miles. oil changes every 3,000 miles. Blazer runs good except when going uphill. SES light blinks then stays on, can't go more than 10-15 mph uphill. SES goes off after couple cycles of new gas. Had ignition switch replaced. Had tune-up. Had PCV valve replaced. Had oxygen sensor placed. Had injector service.
Codes found were P0300, P0151. Any ideas on what to do next? Don't say trade in.

BlazerLT
02-20-2005, 10:31 AM
Clean your MAF sensor with TN cleaner and a gentle toothbrush and get the black crud off of the two small sensor wires. BE GENTLE!

Check fuel pressure?

Did you replace the fuel filter?

blazee
02-20-2005, 11:22 AM
P0151 = HO2S Circuit Low Voltage Bank 2 Sensor 1

BlazerLT
02-20-2005, 02:17 PM
Yes, but the MAF sensor if dirty will cause O2 sensor codes as well.

blazee
02-20-2005, 02:21 PM
I was only stating the code for those attempting to help. When I tried to look it up in my Haynes manual, it wasn't in there. I had to do a web search to find it.

BlazerLT
02-20-2005, 02:24 PM
I was only stating the code for those attempting to help. When I tried to look it up in my Haynes manual, it wasn't in there. I had to do a web search to find it.

Oh, ok , I see. No prob. Was just letting him know before he swapped it out and found that it didn't fix the problem. ;)

Add your comment to this topic!


Quality Real Meat Nutrition for Dogs: Best Air Dried Dog Food | Real Beef Dog Food | Best Beef Dog Food