Intake

I Installed A Intake on My 1997 Nissan Maxima. i just took off the box with the filter at first. i drove it around and everything was fine. then i figured all tha rest of the tubing didint do anything. so i took it out and i think i took out another sensor to ..when i started my car the check engine light came on. i put everything back after that and its still on what should i do???????


Thanks
-Anthony

ok, you actually did not just take the airbox and the piping off right? you added like a cone filter or something I hope, because taking off your box and filter and running your car is basically like dumping sand into your engine...

if you disconnect the battery and then reconnect, the service engine light should go off

do you know where i can get a cold air intake e-mail me at [email protected]

Did you unplug the harness to the Mass Air Flow sensor? That is probably what tripped the MIL light. You can read the codes from the ECU to see what tripped it and then reset it using this:
http://www.seas.ucla.edu/~cheston/images/reset.gif