Neons under seat...help

I just got three more tubes and was going to put two 10" under the driver and pass seat (near the back of the seat) Well when I come to put them in, I noticed that the seat really doesn't have a good place to put them in, there is either metal of that foamy seat stuff. So my question would be, whats the best way to go about putting them in?

I connect the tubes onto thick plastic section that holds to the upholstry to the seat then wire under the carpet to the middle armrest but leave a bit of slack so the seat can move back and forth without obstruction.

Or you just sew it in the carpet if that's a route you wish to take.

I'll take some pics of mine if you want - just email me.

Hey i want to see some pics of that...can you post them?

I have those neon string type lights and i cannot figure out how to install them. The instructions that came with it have no value on telling me what to do. I am stuck and getting pissed off because i don't know how someone can market something without detailed instructions. I also have two more rods that have a 12V DC adapter attached to it and i wanted to know if i cut off the adapter how would i wire it also. If someone can help it would greatly be appreciated. THANKS:flash:

Just use cable ties! I don't have any under my seats, but I did mount neons under the driver and passenger side dash and nothing is screwed in... it's all suspended by cable ties and it worked well under there. It might work for under the seats. ;)

Originally posted by GhettoLegs
Just use cable ties! I don't have any under my seats, but I did mount neons under the driver and passenger side dash and nothing is screwed in... it's all suspended by cable ties and it worked well under there. It might work for under the seats. ;)

Thanks, I just rewired my setup as i installed the three new ones and used the ties to put on the front two, its just gong to be a little tricky getting the seats ones to hang...but i'll see.