Signal light HELL!!!!
imnextc
01-27-2005, 01:57 PM
I am trying to remove my signal lights, and replace with aftermarket lights. I am not able to get to the wiring in the back to remove fender and signal lights, also having problems with the front. If you have any idea how I can get this done, please help. Also if you have an idea of the wiring or diagram that would be great. Thanx
DarkTint
01-27-2005, 04:13 PM
What kind of bike???
Z_Fanatic
01-28-2005, 09:10 AM
:D the topic suggested some intersection mayhem.
imnextc
01-28-2005, 01:02 PM
I'm sorry, the bike is a 2003 Kawasaki Z1000.
k8isgr8
01-28-2005, 03:59 PM
Yes, I thought this was going to be about the intersection lights not changing to green when you're on your bike.
aussieidiot
01-29-2005, 04:00 PM
can't give specific info on your bike but most are very similar.
for the rear you'll have to remove pretty much all the plastics on the tail to get to the harness. don't cut the plugs off your indicators. use line taps (special connectors that enable you to join a new wire to an existing one without cutting) on the socket side of the connector.
as for the front there may be an inner fairing that needs to come off as well as the outer depending on the mounting. with mine i can get to my harness without any removal of any plastic on the front
for the rear you'll have to remove pretty much all the plastics on the tail to get to the harness. don't cut the plugs off your indicators. use line taps (special connectors that enable you to join a new wire to an existing one without cutting) on the socket side of the connector.
as for the front there may be an inner fairing that needs to come off as well as the outer depending on the mounting. with mine i can get to my harness without any removal of any plastic on the front
imnextc
01-30-2005, 04:29 PM
can't give specific info on your bike but most are very similar.
for the rear you'll have to remove pretty much all the plastics on the tail to get to the harness. don't cut the plugs off your indicators. use line taps (special connectors that enable you to join a new wire to an existing one without cutting) on the socket side of the connector.
as for the front there may be an inner fairing that needs to come off as well as the outer depending on the mounting. with mine i can get to my harness without any removal of any plastic on the front
Ok thanx I think that will help I will give it a try then I'll try to get the front started. Thanx again
for the rear you'll have to remove pretty much all the plastics on the tail to get to the harness. don't cut the plugs off your indicators. use line taps (special connectors that enable you to join a new wire to an existing one without cutting) on the socket side of the connector.
as for the front there may be an inner fairing that needs to come off as well as the outer depending on the mounting. with mine i can get to my harness without any removal of any plastic on the front
Ok thanx I think that will help I will give it a try then I'll try to get the front started. Thanx again
NaKeDZX
01-31-2005, 10:14 AM
Check out www.buykawasaki.com for exploded parts views of your bike. May help you find out how it comes apart.
imnextc
01-31-2005, 08:40 PM
Check out www.buykawasaki.com for exploded parts views of your bike. May help you find out how it comes apart.
Yes, that did help Thanx this site has been so helpful Thanx again
Yes, that did help Thanx this site has been so helpful Thanx again
Automotive Network, Inc., Copyright ©2026