Well Blownheadgasket Turns BAD

ok well took of the head and noticed the #2 cylinder coating was gone. headgasket was blown at that point for a long time, and finally blew the outside of it to makeme reliaze it. The spark plug gap was closed and the valves where clean from all the antifreeze in the cyclindar. Ok well im buying a work truck to get me to work and school and back. Im going to pull the engine out and build it up again.

What are yall suggestions, i'll take a few pics and post them but from the look of it, its not that bad but bad enough to have to take the motor out and either resurface or sleeve or bore the cyclinder out. The piston looks good so far as i can only see the top.

Ok start shooting me suggestions.

The most your going to have to do is resurface the head and block. You will probably need to hone the cylinder walls too. This would be a nice time to probably upgrade to better pistons and such, if your income allows it. I would wait till you got the block out and disassembled before you really find out what the damage is.`