Rebuilding Engine...

Whats up guys. I have a 95 S14 with the KA and I just pulled the engine to replace the timing kit and the clutch. I know that I am also going to get my flywheel resurfaced and replace the crank seal that is leaking, but I was just wondering if you guys could think of anything else that I should look into. The engine has 160K on it and I will probably do the SR swap within a year, so thats why I am not completely rebuilding it. But if you guys think of anything else I should replace or check while the engine's out, please let me know. Thanks a lot guys.

I was ganna say get forged pistons, but if you're not ganna turbo, there's no point.

damn thats funny i have a '95 and i need to do exactly the same shit pretty much. its getting there i can tell. same miles too....not a fun club to be a part of but looks like you have the funds to take care of it so its all good.

i feel you guys about having to fix a lot of crap. my 240 is hurtin bad. I just want to get it running right for a little bit until i can drop the sr20 in it

there might not be any point in investing money into that engine if you're putting an sr into it.. i know its always good to have an extra just incase shit happens but honestly don't put too much money into it.. but if you wanted advice, i'd check all gaskets and seals.. there isn't much else you can do in your case cause going any further (like logik's idea) would cost way too much

PCV valve will be easier to access. Check all your vacuum lines while its out.

Thanks a lot guys.