CD Burner Problems
Feint Motion
12-31-2004, 12:18 AM
I have an HP Desktop, had it since 2002. Since then I havent been able to burn/play anything im my CD drive. I've done system recovery, and still no luck. My DVD drive works perfect, and I now have to use that drive play all my cd's,etc. When I insert a CD(blank, Cd-rom), it make a noise, (spins fast) & it dosent read anything. Dose anyone know a soulution? I've tried CD cleaners, never read the cd.
pre98zetec
12-31-2004, 12:21 AM
HP CD/rw drives in general are JUNK. Buy a new one and that'll fix your problem.
my3rdskyline
12-31-2004, 03:47 AM
or have one of your computer savy friends come over and mess with your computer. it's usually to difficult to explain the little troubleshooting steps I take....
Plastic_Fork
12-31-2004, 12:06 PM
HP CD/rw drives in general are JUNK. Buy a new one and that'll fix your problem.
Right you are. 90% of the computers I worked on at the repair shop were HP's or Compaq's.
Feint Motion:
Make sure the IDE cable is connected properly to the CD writer and other devices, make sure the jumpers on both optical drives are set correctly, and try again. If you still have issues with the writer reading any discs, it's a dead drive and will need to be replaced.
Either something's out of alignment, the servos are shot, or the laser isn't functioning correctly. Any of the above spells a new CD writer.
Right you are. 90% of the computers I worked on at the repair shop were HP's or Compaq's.
Feint Motion:
Make sure the IDE cable is connected properly to the CD writer and other devices, make sure the jumpers on both optical drives are set correctly, and try again. If you still have issues with the writer reading any discs, it's a dead drive and will need to be replaced.
Either something's out of alignment, the servos are shot, or the laser isn't functioning correctly. Any of the above spells a new CD writer.
Feint Motion
01-13-2005, 09:33 PM
Right you are. 90% of the computers I worked on at the repair shop were HP's or Compaq's.
Feint Motion:
Make sure the IDE cable is connected properly to the CD writer and other devices, make sure the jumpers on both optical drives are set correctly, and try again. If you still have issues with the writer reading any discs, it's a dead drive and will need to be replaced.
Either something's out of alignment, the servos are shot, or the laser isn't functioning correctly. Any of the above spells a new CD writer.
Thanks! I Figure it was the lense, since I burned some old cd's for a friend back in 2002(they were dirty, didnt wipe them off).
Feint Motion:
Make sure the IDE cable is connected properly to the CD writer and other devices, make sure the jumpers on both optical drives are set correctly, and try again. If you still have issues with the writer reading any discs, it's a dead drive and will need to be replaced.
Either something's out of alignment, the servos are shot, or the laser isn't functioning correctly. Any of the above spells a new CD writer.
Thanks! I Figure it was the lense, since I burned some old cd's for a friend back in 2002(they were dirty, didnt wipe them off).
Plastic_Fork
01-15-2005, 12:03 AM
Might want to have a shot at a CD lens cleaner and see what that does for you. If it's still problematic, you'd probably be better off replacing the writer. The lens could be scratched or something.
Automotive Network, Inc., Copyright ©2026